TPU Paint Protection Film for BJ60（2024-2026 models）

[Transparent Soft Film Installation Instructions]

Lubrication Solution Preparation:
Add 1 drop of dishwashing liquid (about the size of a soybean) into a spray bottle filled with water. Shake well to mix thoroughly.

Installation Steps:

1. Clean the surface where the film will be applied thoroughly. Then lightly spray the area with the prepared soapy water.
2. Spray an even layer of the soapy water onto the adhesive side of the protective film.
3. Carefully place the film onto the target area and adjust its position as needed.
4. Spray a small amount of soapy water on the outer surface of the film. This helps the squeegee move smoothly during water removal and prevents the film from shifting or sticking too quickly.
5. Use a squeegee to remove the water. For areas with strong curves, press more firmly to ensure proper adhesion.
6. If the position is not correct, you can peel it off, spray more soapy water, and reapply.

Important Notes:

• Always install using soapy water (this step is essential).
• If there are small air bubbles or water marks, do not worry.
  They will gradually disappear as the water evaporates over the next few days.